My bitaxe keeps freezing at around 3.4 GH/s. I refresh it and it works again, but every few days it seems to be freezing again. I attached the readings while frozen... I was wondering if maybe I should just flash it with the new firmware again?
Notifications
Clear all
Apr 05, 2025 6:17 pm
2 Replies
Apr 05, 2025 9:32 pm
Temps all look fine. Have you tried unplugging it for a couple minutes and plugging it back in? You could also try the reset button, but in my experience unplugging gives a better reset. This is a long shot but it could also be caused by a loose part somewhere, such as the heat sink. Based on temp readings I'd say your heat sink is perfect, but you could check the screws just in case. Wish I had better suggestions.
Apr 05, 2025 11:08 pm
Flashing is frequently recommended as an initial troubleshooting step in situations like this, but unless your firmware is outdated flashing it again probably won't make any difference. I would start by slightly increasing the core voltage and let us know how that goes.
Forum Statistics
4
Forums
32
Topics
126
Posts
0
Online
30
Members
Latest Post: Trying to understand "best difficulty" Our newest member: alamgirdev24 Recent Posts Unread Posts
